Skip to main content
Ch.18 - Chemistry of the Environment
Chapter 18, Problem 80

The water supply for a midwestern city contains the following impurities: coarse sand, finely divided particulates, nitrate ions, trihalomethanes, dissolved phosphorus in the form of phosphates, potentially harmful bacterial strains, dissolved organic substances. Which of the following processes or agents, if any, is effective in removing each of these impurities: coarse sand filtration, activated carbon filtration, aeration, ozonization, precipitation with aluminum hydroxide?

Verified Solution

Video duration:
1m
This video solution was recommended by our tutors as helpful for the problem above.
Was this helpful?

Key Concepts

Here are the essential concepts you must grasp in order to answer the question correctly.

Filtration

Filtration is a physical separation process that removes solid particles from liquids or gases by passing the mixture through a filter medium. Coarse sand filtration is effective for removing larger particles, such as sand and debris, while activated carbon filtration targets smaller organic compounds and impurities, including trihalomethanes and dissolved organic substances.
Recommended video:
Guided course
04:50
Filtration and Evaporation

Chemical Precipitation

Chemical precipitation involves adding a chemical agent to a solution to form solid particles that can be removed from the liquid. In this context, aluminum hydroxide can precipitate dissolved phosphates, effectively reducing phosphorus levels in water, which is crucial for preventing eutrophication in aquatic systems.
Recommended video:
Guided course
01:53
Selective Precipitation

Ozonization and Aeration

Ozonization is a water treatment process that uses ozone gas to oxidize organic and inorganic contaminants, including bacteria and trihalomethanes, making them easier to remove. Aeration, on the other hand, introduces air into water, promoting the removal of volatile compounds and enhancing the oxidation of dissolved substances, which can help in reducing harmful bacterial strains.
Recommended video:
Guided course
00:46
Formation Equations Example 1
Related Practice
Textbook Question

(b) Concentrations of lead in the bloodstream are often quoted in units of μg/dL. Averaged over the entire country, the mean concentration of lead in the blood was measured to be 1.6 μg/dL in 2008. Express this concentration in ppb.

378
views
Textbook Question

The estimated average concentration of NO2 in air in the United States in 2006 was 0.016 ppm. (a) Calculate the partial pressure of the NO2 in a sample of this air when the atmospheric pressure is 755 torr (99.1 kPa).

503
views
Textbook Question

In 1986 an electrical power plant in Taylorsville, Georgia, burned 8,376,726 tons of coal, a national record at that time. (a) Assuming that the coal was 83% carbon and 2.5% sulfur and that combustion was complete, calculate the number of tons of carbon dioxide and sulfur dioxide pro- duced by the plant during the year.

1468
views
Textbook Question

An impurity in water has an extinction coefficient of 3.45⨉103 M-1 cm-1 at 280 nm, its absorption maximum (A Closer Look, p. 576). Below 50 ppb, the impurity is not a problem for human health. Given that most spectrometers cannot detect absorbances less than 0.0001 with good reliability, is measuring the absorbance of a water sample at 280 nm a good way to detect concentrations of the impurity above the 50-ppb threshold?

474
views
Textbook Question

The concentration of H2O in the stratosphere is about 5 ppm. It undergoes photodissociation according to: H2O1g2 ¡ H1g2 + OH1g2 (b) Using Table 8.3, calculate the wavelength required to cause this dissociation.

469
views
Textbook Question

The following data were collected for the desturction of O3 by H (O3 + H → O2 + OH) at very low concentrations (b) Calculate the rate constant

324
views