A conducting rod of length $l$ moves with constant velocity $v$ perpendicular to a uniform magnetic field of magnitude $B$. What is the magnitude $e$ of the motional emf induced in the rod?

A thin rod moves in a perpendicular, unknown magnetic field. If the length of the rod is 10 cm and the induced EMF is 1 V when it moves at 5 m/s, what is the magnitude of the magnetic field?

INT A 20-cm-long, zero-resistance slide wire moves outward, on zero-resistance rails, at a steady speed of 10 m/s in a 0.10 T magnetic field. (See Figure 30.26.) On the opposite side, a 1.0 Ω carbon resistor completes the circuit by connecting the two rails. The mass of the resistor is 50 mg. How much force is needed to pull the wire at this speed?

A potential difference of 0.050 V is developed across the 10-cm-long wire of FIGURE EX30.3 as it moves through a magnetic field perpendicular to the figure. What are the strength and direction (in or out) of the magnetic field?

A 22.0-cm-diameter coil consists of 36 turns of circular copper wire 2.6 mm in diameter. A uniform magnetic field, perpendicular to the plane of the coil, changes at a rate of 8.65 x 10^-3 T/s. Determine (a) the current in the loop, and (b) the rate at which thermal energy is produced.

A long horizontal wire carries 24.0 A of dc current due north. What is the net magnetic field 20.0 cm due west of the wire if the Earth’s field there points downward, 38° below the horizontal, and has magnitude 5.0 x 10^-5 T?

A simple generator is designed to generate a peak output voltage of 24.0 V. The square armature consists of windings that are 5.15 cm on a side and rotates in a field of 0.380 T at a rate of 60.0 rev/s. How many loops of wire should be wound on the square armature?

A generator rotates at 85 Hz in a magnetic field of 0.030 T. It has 950 turns and produces an rms voltage of 150 V and an rms current of 60.0 A. (a) What is the peak current produced? (b) What is the area of each turn of the coil?