Skip to main content
Ch.18 - Aqueous Ionic Equilibrium
Chapter 18, Problem 129

Calculate the solubility of CuX in a solution that is 0.150 M in NaCN. Ksp for CuX is 1.27⨉10-36.

Verified Solution

Video duration:
8m
This video solution was recommended by our tutors as helpful for the problem above.
Was this helpful?

Key Concepts

Here are the essential concepts you must grasp in order to answer the question correctly.

Solubility Product Constant (Ksp)

The solubility product constant (Ksp) is an equilibrium constant that applies to the solubility of sparingly soluble ionic compounds. It is defined as the product of the molar concentrations of the ions, each raised to the power of their coefficients in the balanced equation. For a compound like CuX, Ksp helps determine how much of the compound can dissolve in a solution before reaching saturation.
Recommended video:
Guided course
01:47
Solubility Product Constant

Common Ion Effect

The common ion effect refers to the decrease in solubility of an ionic compound when a common ion is added to the solution. In this case, the presence of NaCN introduces CN⁻ ions, which shifts the equilibrium of the dissolution of CuX, reducing its solubility. Understanding this effect is crucial for calculating the new solubility in the presence of a common ion.
Recommended video:
Guided course
02:53
Common Ion Effect

ICE Table (Initial, Change, Equilibrium)

An ICE table is a tool used to track the concentrations of reactants and products during a chemical reaction at different stages: Initial, Change, and Equilibrium. For solubility calculations, it helps organize the initial concentrations of ions, the changes that occur as the system reaches equilibrium, and the final concentrations. This systematic approach is essential for accurately determining the solubility of CuX in the given solution.
Recommended video:
Guided course
01:14
ICE Charts and Equilibrium Amount
Related Practice
Textbook Question

A 5.55-g sample of a weak acid with Ka = 1.3⨉10-4 was combined with 5.00 mL of 6.00 M NaOH, and the resulting solution was diluted to 750.0 mL. The measured pH of the solution was 4.25. What is the molar mass of the weak acid?

996
views
2
comments
Textbook Question

Pseudogout, a condition with symptoms similar to those of gout (see Problem 126), is caused by the formation of calcium diphosphate (Ca2P2O7) crystals within tendons, cartilage, and ligaments. Calcium diphosphate will precipitate out of blood plasma when diphosphate levels become abnormally high. If the calcium concentration in blood plasma is 9.2 mg/dL, and Ksp for calcium diphosphate is 8.64⨉10-13, what minimum concentration of diphosphate results in precipitation?

433
views
1
comments
Textbook Question

Calculate the solubility of silver chloride in a solution that is 0.100 M in NH3.

966
views
Textbook Question

A 0.867-g sample of an unknown acid requires 32.2 mL of a 0.182 M barium hydroxide solution for neutralization. Assuming the acid is diprotic, calculate the molar mass of the acid.

1269
views
Textbook Question

A 25.0-mL volume of a sodium hydroxide solution requires 19.6 mL of a 0.189 M hydrochloric acid for neutralization. A 10.0-mL volume of a phosphoric acid solution requires 34.9 mL of the sodium hydroxide solution for complete neutralization. Calculate the concentration of the phosphoric acid solution.

1304
views
Textbook Question

What should the molar concentrations of benzoic acid and sodium benzoate be in a solution that is buffered at a pH of 4.55 and has a freezing point of -2.0 °C? (Assume complete dissociation of sodium benzoate and a density of 1.01 g/mL for the solution.)

1037
views